Vorige
Volgende
LSL Clamp Kit Ø 28.6 YAMAHA XSR 900, black
Product description
X-Bar clamps (identification KM45) for 28,6 mm handlebars \suitable for following vehicle:
Yamaha
XSR 900
Entry currently only by single acceptance (§19.2)! Supplement in preparation!
Material: Aluminium
Material treatment: anodized
Fixing: at original fixing points
Offset: + 10 mm
Dimensions: 28.6 mm Clamping: 28.6 mm
Our model-specific X-Bar clamps are mounted at the original fixing points. So many models with original 22.2mm handlebars can mount an X-Bar handlebar.
On models with standard rubber mounts, this is retained. Depending on the model, the handlebar position changes from -50mm to +30mm, the value for your motorcycle is indicated under offset.
\NEWNOTE IMPORTANT NOTE: Please check before the conversion whether the vehicle intended for the conversion is listed in the attached ABE!
For each vehicle there are different conditions and requirements that allow a conversion of the clamp blocks.
The model assignments of the LSL terminal blocks listed in the ABE are tested for use with the vehicle's standard handlebar.
The additional use of an LSL accessory handlebar is possible, but may require additional modifications to the vehicle (longer cables or cables) due to a different shape of the handlebar.
The increase in the original handlebar can also lead to additional modifications to the vehicle.
Check whether the following conditions apply to your vehicle (-see ABE):
- Use permitted when using a fork bridge compensation pad
- With 20 mm longer brake line Use permitted
- With 30 mm longer brake line Use permitted
- With LSL instrument holder Use permitted
Failure to observe these instructions will void the vehicle's operating permit!
The following items are suitable for this product: 28.6 mm handlebars X-Bar
Yamaha
XSR 900
Entry currently only by single acceptance (§19.2)! Supplement in preparation!
Material: Aluminium
Material treatment: anodized
Fixing: at original fixing points
Offset: + 10 mm
Dimensions: 28.6 mm Clamping: 28.6 mm
Our model-specific X-Bar clamps are mounted at the original fixing points. So many models with original 22.2mm handlebars can mount an X-Bar handlebar.
On models with standard rubber mounts, this is retained. Depending on the model, the handlebar position changes from -50mm to +30mm, the value for your motorcycle is indicated under offset.
\NEWNOTE IMPORTANT NOTE: Please check before the conversion whether the vehicle intended for the conversion is listed in the attached ABE!
For each vehicle there are different conditions and requirements that allow a conversion of the clamp blocks.
The model assignments of the LSL terminal blocks listed in the ABE are tested for use with the vehicle's standard handlebar.
The additional use of an LSL accessory handlebar is possible, but may require additional modifications to the vehicle (longer cables or cables) due to a different shape of the handlebar.
The increase in the original handlebar can also lead to additional modifications to the vehicle.
Check whether the following conditions apply to your vehicle (-see ABE):
- Use permitted when using a fork bridge compensation pad
- With 20 mm longer brake line Use permitted
- With 30 mm longer brake line Use permitted
- With LSL instrument holder Use permitted
Failure to observe these instructions will void the vehicle's operating permit!
The following items are suitable for this product: 28.6 mm handlebars X-Bar
| Homologation | ABE Approved |
|---|