Vorige
Volgende
LSL Stuurklemmen-set 28,6 kit Kawasaki Z650 17- zwart
Product beschrijving
X-Bar clamps (identification KM45) black for 28,6 mm handlebars
suitable for the following vehicle:
Kawasaki
Z650 year of construction 2017-
registration currently only by single acceptance (�19.2)
Material: aluminium
Material treatment: anodized
Material treatment: + 15 mm
Additional mounting: at original mounting points
Dimensions: 28.6 mm Clamping
Our model-specific X-Bar clamps are mounted at the original mounting points. This means that an X-Bar handlebar can be mounted on many models with original 22.2mm handlebars.
For models with standard rubber mountings, this is retained. Depending on the model, the handlebar position changes from -50mm to +30mm, the value for your bike is given under offset.
ATTENTION IMPORTANT NOTE: Before conversion, please check whether the vehicle intended for conversion is listed in the ABE attached here!
For each vehicle there are different requirements and conditions which make it possible to convert the clamps.
The model allocations of the LSL clamping blocks listed in the ABE have been tested for use with the standard control arm of the vehicle.
The additional use of an LSL accessory handlebar is possible, but may require additional modifications to the vehicle (longer cables or trains) due to a different shape of the handlebar.
Increasing the original handlebars can also lead to additional modifications to the vehicle.If this is not observed, the operating licence for the vehicle expires!
The following articles fit to this product: 28,6 mm handlebar X-Bar
suitable for the following vehicle:
Kawasaki
Z650 year of construction 2017-
registration currently only by single acceptance (�19.2)
Material: aluminium
Material treatment: anodized
Material treatment: + 15 mm
Additional mounting: at original mounting points
Dimensions: 28.6 mm Clamping
Our model-specific X-Bar clamps are mounted at the original mounting points. This means that an X-Bar handlebar can be mounted on many models with original 22.2mm handlebars.
For models with standard rubber mountings, this is retained. Depending on the model, the handlebar position changes from -50mm to +30mm, the value for your bike is given under offset.
ATTENTION IMPORTANT NOTE: Before conversion, please check whether the vehicle intended for conversion is listed in the ABE attached here!
For each vehicle there are different requirements and conditions which make it possible to convert the clamps.
The model allocations of the LSL clamping blocks listed in the ABE have been tested for use with the standard control arm of the vehicle.
The additional use of an LSL accessory handlebar is possible, but may require additional modifications to the vehicle (longer cables or trains) due to a different shape of the handlebar.
Increasing the original handlebars can also lead to additional modifications to the vehicle.If this is not observed, the operating licence for the vehicle expires!
The following articles fit to this product: 28,6 mm handlebar X-Bar
| Keurmerk | ABE Gekeurd |
|---|