LSL Stuurklemmen-set MT-01 28,6/zwart

X-Bar clamping brackets (identification KM45) for 28.6 mm handlebars
suitable for the following vehicle:
Yamaha
MT01

material: aluminium
material treatment: anodized
offset: - 13 mm
dimensions: 28.6 mmClamping

Our model-specific X-Bar clamps are mounted at the original mounting points. So you can mount an X-Bar handlebar on many models with original 22,2mm handlebars.
formodels with standard rubber mountings, this is retained. Depending on the model, the handlebar position changes from -50mm to +30mm, the value for your motorcycle is given under offset.

AttentionIMPORTANT NOTE: Please check before the conversion whether the vehicle intended for the conversion is listed in the ABE attached here!
For each vehicle there are differentPrerequisites and requirements that enable the conversion of the clamping blocks.
The model assignments of the LSL clamping blocks listed in the ABE have been tested for use with the standard control armof the vehicle.
The additional use of an LSL accessory handlebar is possible, but due to a different shape of the handlebar additional modifications to the vehicle (longer cablesor trains).
Even the raising of the original handlebars can lead to additional modifications to the vehicle.
Check whether the following conditions apply to your vehicle (-seeABE):
- use permitted when using a compensating pad for the triple clamp
- with 20 mm longer brake line use permitted
- with 30 mm longer brake line usepermissible
- with LSL instrument holder Use permissible

If not observed, the vehicle's type approval expires!

The following articles fit this product: 28.6 mm handlebars X-Bar